링크 : http://www.ietf.org/html.charters/16ng-charter.html

Broadband Wireless Access Networks address the inadequacies of low
bandwidth wireless communication for user requirements such as high
quality data/voice service, wide coverage, etc. The IEEE 802.16 Working
Group on Broadband Wireless Access Standards develops standards and
recommended practices to support the development and deployment of
Broadband Wireless Metropolitan Area Networks.

A particularity of IEEE 802.16 is that it does not include a rigid
upper edge MAC service interface. Instead, it provides
multiple "convergence sublayers (CS)" with the assumption that the
choice and configuration of the upper edge will be done in accordance
with the needs of a specific deployment environment (which might be
DSL replacement, mobile access, 802.11 or CDMA backhaul etc.).

Specifically, immediately subsequent to network entry, an 802.16
subscriber station has no capability whatsoever for data (as opposed
to management) connectivity. Especially, in IP CS case, the criteria
by which the Base Station (or other headend elements) sets up the
802.16 MAC connections for data transport are not part of the 802.16
standard, and depend on the type of data services being offered (e.g.,
the set up of link layer connections will be different for IPv4 and
IPv6 services).

Additionally - as IEEE 802.16 is a point-to-multipoint network - an
802.16 subscriber station is not capable of multicasting (e.g., for
neighbor discovery, ARP, IP multicasting services, etc.) or direct
communication to the other nodes attached to the same Base Station
within the same subnet (prefix).

Unlike 3G or xDSL technologies, IEEE 802.16 is not part of an end-to-
end system definition. Currently, the WiMAX Forum, and, in particular,
its NWG (Network Working Group) is defining a network architecture
based on IEEE 802.16.

The principal objective of the 16ng working group is to specify the
operation of IPv4 and IPv6 over IEEE 802.16, taking into account the
IPv4, IPv6 and Ethernet Convergence Sublayers. The working group may
issue recommendations to IEEE 802.16 and WiMax aiming at improving
support for IP.

The scope of this working group is as follows (WG Deliverables);

- Produce "16ng Problem Statement, Goal and Requirement" to identify
the specific gaps in the 802.16 MAC for IPv4/IPv6 support, describe
possible network models (ie. point-to-point, broadcast etc.), and
provide 16ng related terminology to be used for the base guideline
while defining solution frameworks. [Informational RFC]

- Produce "IPv6 over IEEE 802.16 Networks in conjunction with IPv6 CS"
to define IPv6 operation including the transmission of IPv6 over IEEE
802.16 link, Neighbor Discovery Protocol, Stateful (DHCPv6) and
Stateless Address Configuration, Broadcast, Multicast, etc. [Proposed
Standard RFC]

- Produce "IPv6 over IEEE 802.16 Networks in conjunction with Ethernet
CS" to define IPv6 operation including the transmission of IPv6 over
IEEE 802.16 link, Neighbor Discovery Protocol, Stateful (DHCPv6) and
Stateless Address Configuration, Broadcast, Multicast, etc. [Proposed
Standard RFC]

- Produce "IPv4 over IEEE 802.16 Networks in conjunction with IPv4 CS"
to define IPv4 operation including the transmission of IPv4 over IEEE
802.16 links, ARP operation, Stateful Address Configuration (DHCPv4),
Broadcast, Multicast, etc [Proposed Standard RFC]

- Produce "IPv4 over IEEE 802.16 Networks in conjunction with Ethernet
CS" to define IPv4 operation including the transmission of IPv4 over
IEEE 802.16 links, ARP operation, Stateful Address Configuration
(DHCPv4), Broadcast, Multicast, etc [Proposed Standard RFC]

- Produce "IP deployment over IEEE 802.16 Networks" to illustrate the
IP deployment scenarios including IP CS and Ethernet CS considerations
over IEEE 802.16 networks based on the WiMAX and WiBro. [Informational
RFC]

This working group will take dual stack operation into account in its
specifications, and reuse existing specifications whenever reasonable
and possible. The ability to negotiate the used Convergence Sublayer is
required, as no single mandatory CS can be specified for the clients.
Work based on the Ethernet CS needs to take into account
interoperability with existing hosts and other devices that employ
Ethernet? to allow bridging.

16ng will not initially consider other work items than the ones listed
above; however, other related work may occur in other WGs, and 16ng
will participate and help such efforts.

크리에이티브 커먼즈 라이센스

이 저작물은 크리에이티브 커먼즈 코리아 저작자표시-비영리-변경금지 2.0 대한민국 라이센스에 따라 이용하실 수 있습니다.

(0) (0)